Another Electrical Diagnosis: Marker Lights Flash With Turn Signals?
Anderson Fleet Service · Kinsman, OH
Got a call on a 2019 Ford E-350 rig with one of those problems that looks a lot bigger than it is. Hit the left turn signal and every marker light on the whole rig flashed right along with it.
When the whole truck lights up like a Christmas tree off one signal, your brain goes straight to a big wiring problem. Shorted harness, something rubbed through behind the body, a bad module. Sometimes it is. This time it wasn’t.
Step 1: Start where the rust lives
We’re in the rust belt. Corrosion is always on the suspect list, and trailer wiring connections are one of the first places it shows up. Salt, water, and nobody looks at them until something quits.
So I checked the trailer connections first. Corrosion was bad. No surprise there. But the connections were OK and weren’t the cause. Moving on.
Step 2: The fuse that wasn’t the answer
Next I found a bad fuse for the trailer lights. Easy, right? Replaced it, hit the left signal…
Markers still flashing.
That fuse needed replacing anyway, but it wasn’t causing this. Good reminder: finding a problem isn’t the same as finding the problem.
Step 3: The culprit was a bulb
It only happened with the left signal, so I stayed on the left side and kept it simple. Pulled the left front turn signal bulb.
There it was.
That’s a dual-filament bulb. One filament for the parking light, one for the turn signal. The turn signal filament had broken and fallen onto the parking light filament.
So every time the left signal flashed, that broken filament fed turn signal power right into the parking light circuit. The markers ride on that same circuit, so the whole rig got it. Backfed power to every marker light on the truck.
New bulb, problem gone. Yeah, that’ll do it.
Takeaways from the field
- If it only happens with one signal, check that side’s bulbs before you start tearing into harnesses.
- A dual-filament bulb can tie two circuits together when it fails. Look at the filaments, don’t just check whether it lights.
- Fix the bad fuse, sure, but test again before you call it done. One fault can hide behind another.
- Corrosion is always worth a look up here. Just don’t stop at the first ugly connector you find.
Final word
The weird ones aren’t always the hard ones. Work it from simple to complex and let the symptom point you where to look. If your rig’s lights are doing something they shouldn’t, give us a call.
More on electrical gremlins: 5 Signs Your Ambulance Has an Electrical Problem and An Electrical Preventive-Maintenance Checklist.
Related reading: Emergency Lights With a Mind of Their Own.
Rig down? Talk to the tech directly.
On-site ambulance electrical, equipment, and eLock work across Ohio and Pennsylvania. You reach Phil, not a call center.